DISC-GRINDING 4C3769 - Caterpillar

Introduction
This Special Instruction Provides the instruction to install tie off plate on the machines listed above. The new plate installed is to provide human safety.Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Safety Section
Important Safety Information
Do not perform any procedure in this special instruction until you have read this special instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons.Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe. Ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures that are used.
Personal injury or death can result from improper assembly procedures.Do not attempt any assembly until you have read and understand the assembly instructions.
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Power Locked and Tagged out
Turn off the engine with the keyswitch to the "OFF" position. Insure that the machine has been turned off and is locked and tagged out.Use proper Lock out and Tag out procedures. Attach a "Do Not Operate" warning tag to the machine start switch or the controls before you perform any service to the machine. These warning tags Special Instruction, SEHS7332 are available from your Caterpillar Dealer.Electrical Safety
"DO NOT" operate or work on a machine unless you have read and understand the instructions and warnings in this manual and the Machine Control and Installation Guide. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat® Dealer for replacement manuals. Proper care is your responsibility.Note: During installation, it is important to protect wiring in key