DISC 5448442 - Caterpillar

"Machine Radio Configuration"
The "Machine Radio Configuration" utility allows you to change the network number or the frequency channel on the data radios. The "Machine Radio Configuration" utility runs on the display.To open the "Machine Radio Configuration" dialog, complete the following steps:
In service mode, select the "Installation" soft key from the "Setup" menu.
Illustration 1 g01451159
Press the arrow keys until "Machine Radio Configuration" is highlighted. Press the "OK" key.The utility automatically attempts to connect to the radio. A screen that is similar to Illustration 2 appears.
Illustration 2 g01751093
Use the arrow keys (8) in order to select the same network as the base station for CR900 radios. Use the arrow keys (8) to select the same frequency as the base station for CR450 radios."Display's Radio Port"
When a radio that is manufactured by a third party is used, the display for the AccuGrade System allows the user to adjust the following communication parameters:
Baud Rate
ParityUse the "Display's Radio Port" dialog in order to control the speed that the display communicates with the radio. These settings do not affect the speed of data transfer though the air between radios. Refer to the following Steps in order to adjust the "Display's Radio Port" settings.
Illustration 3 g01265962
(1) LCD (2) Soft Key Labels (3) Soft Keys (4) Escape Key (5 ) Next Key (6) Power Key (7) "+" Key (8) Arrow Keys (9) "-" Key (10) "OK" Key (11) Menu Key (12) "Data Card Slot"
To view all options in the "Setup Menu" dialog, start the AccuGrade System in service mode.
Hold down the "OK" key and press the power key while the display powers up.
Press the menu key (11) .
Select the soft key that is located beside the "Installation" soft key label from the "Setup" menu.
Illustration 4 g01451159
Press the arrow keys until "Display's Radio Port" is highlighted.
Illustration 5 g01288144
Press the "OK" key (10) .A screen that is similar to Illustration 5 will appear.
Press the up arrow or the down arrow in order to adjust the "Baud Rate". Press the Next Key (5) in order to toggle between the "Display Radio Port" fields.
Press the up arrow or the down arrow in order to adjust the "Parity".
Press the "OK" key (10) .