DISC 5451535 - Caterpillar

Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g00633843
Install O-ring seal (12) on plug (13). Apply clean hydraulic oil on the seal. Install plug (13) .
Install seals (9) and O-ring seals (10) into outside housing (8).
Carefully install outside housing (8) over rotor (11) .
Install retainer (6), washers (5), and bolts (4). This holds the rotor (11) and the outside housing (8) together.
Apply clean hydraulic oil on O-ring seal (7). Install the O-ring seal in the outside housing.
Install cover (3), washers (2), and bolts (1) that secure the cover.
Check the swivel joint for leaks. Plug the drain ports of the inside body. Apply shop air pressure in the top of the swivel joint and check the swivel joint for leaks. The shop air pressure should be between 0.2758 MPa (40 psi) and 0.4137 MPa (60 psi).End By: Install the swivel joint. Refer to Disassembly and Assembly, "Swivel - Install".