DISC-FRICTION 6I9695 - Caterpillar

Removal Procedure
Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g01192452
Disconnect harness assembly (1). Disconnect hose assemblies (2), (3), and (4) .
Illustration 2 g01192454
Remove bolts (6) and cover (5) .
Illustration 3 g01192456
Remove bolts (7) and cover (8) .
Illustration 4 g01192458
Disconnect harness assemblies (10) and (11) from terminal (9) .
Illustration 5 g01192459
Attach a suitable lifting device to generator (12). The weight of generator (12) is approximately 193 kg (425 lb). Remove bolts (13) and generator (12) .