DISC-FRICTION 6P3089 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 439-3939 Link Bracket Assembly 1
B 8T-5096 Dial Indicator Gp 1
C 1U-9895 Cross Block 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g06244224
Lower the temperature of bearing cup (23). Install bearing race (23).
Illustration 2 g06244833
Raise the temperature of bearing cone (22). Install bearing cone (22). Repeat this step for the remaining bearing cone.
Illustration 3 g06244453
Install ring seal (21).
Illustration 4 g06244435
Install pump drive gear (20).
Illustration 5 g06244206
Install the O-ring seal onto speed sensor (19). Install speed sensor (19).
Install bolt (18). Tighten bolt (18) to a torque of 14 3 N m (124 26.5 lb in)
Illustration 6 g06244481
Lower the temperature of bearing cup (17). Install bearing cup (17). Install the cover plate.
Illustration 7 g06244061
Install O-ring seal (16). Install bearing race (15).
Illustration 8 g06245552
Install pump adapter (14).
Install bolts (13). Tighten bolts (13) to a torque of 55 10 N m (41 7.4 lb ft).
Install Tooling (A). Use suitable lifting device to reposition torque converter housing (3) 180 degrees. The weight of the torque converter housing (3) is approximately 104 kg (230 lb).
Illustration 9 g06245561Note: Typical Example.
Use Tooling (B) to measure the end play of pump drive gear (20). The end play measurement must be 0.10 to 0.20 mm (0.004 to 0.008 inch). Add or remove shims in order to obtain the correct end play.
Repeat steps for the remaining pump drive gear.
Illustration 10 g06243781
Install bearing assembly (12).
Install idler gear assembly (11).
Illustration 11 g06244917
Lower the temperature of idler shaft (10). Install idler shaft (10).
Install bolt (9).