DISC 6Y7962 - Caterpillar

High Pressure Cylinder (Front Suspension Cylinder) (7)This warning label is located on each front suspension cylinder.
g01149997
HIGH PRESSURE CYLINDERDo not remove any valve, hydraulic fitting, or valve core, nor disassemble any parts until pressure has been relieved.To relieve pressure, truck frame must be properly supported. Failure to comply with this warning will cause unexpected machine movement resulting in serious injury or death.Refer to your Service Manual for correct procedures for relieving pressure and/or correct charging procedures.See your Caterpillar dealer who has tools and detailed information for servicing and charging cylinders.
For information on servicing the suspension cylinders, refer to Special Instruction, SEHS9411, "Suspension Cylinder Servicing".High Pressure Cylinder (Rear Suspension Cylinder) (8)This warning label is located on each rear suspension cylinder.
g01149997
HIGH PRESSURE CYLINDERDo not remove any valve, hydraulic fitting, or valve core, nor disassemble any parts until pressure has been relieved.To relieve pressure, truck frame must be properly supported. Failure to comply with this warning will cause unexpected machine movement resulting in serious injury or death.Refer to your Service Manual for correct procedures for relieving pressure and/or correct charging procedures.See your Caterpillar dealer who has tools and detailed information for servicing and charging cylinders.
For information on servicing the suspension cylinders, refer to Special Instruction, SEHS9411, "Suspension Cylinder Servicing".Improper Connections For Jump Start Cables (9)This warning label is located on the battery access cover.
g00038786
IMPROPER JUMPER CABLE CONNECTIONS CAN CAUSE EXPLOSION RESULTING IN PERSONAL INJURY.BATTERIES MAY BE LOCATED IN SEPARATE COMPARTMENTS. WHEN USING JUMPER CABLES, ALWAYS CONNECT POSITIVE (+) CABLE TO POSITIVE (+) TERMINAL OF BATTERY CONNECTED TO STARTER SOLENOID AND NEGATIVE (-) CABLE FROM EXTERNAL SOURCE TO STARTER NEGATIVE (-) TERMINAL (IF MACHINE NOT EQUIPPED WITH STARTER NEGATIVE TERMINAL, CONNECT TO ENGINE BLOCK.) FOLLOW PROCEDURE IN THE OPERATION MANUAL.
High Compressed Spring (10)This warning label is located on the front brake master cylinder and on the rear brake master cylinder.
g00100414
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Do Not Weld The ROPS (Earlier Machines) (11)This warning label is located outside the cab on the right side of the ROPS.
g00100417
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Do Not Weld The ROPS (Later Machines) (11)This warning label is located outside the cab on the right side of the ROPS.
g01125202
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.