DISC A 8E2154 - Caterpillar

Illustration 1 g01807233
Typical ExampleThere are specific safety messages on this work tool. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiarized with all safety messages.Make sure that all of the safety signs are legible. Clean the safety signs or replace the safety signs if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the safety signs, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety sign. Loose adhesive will allow the safety sign to fall. Replace any safety sign that is damaged or missing. If a safety sign is attached to a part that is replaced, install a safety sign on the replacement part. Your Caterpillar dealer can provide new safety signs.Do Not Operate (1)This safety message is located at the rear of the work tool near the serial number plate.
g01051172
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Crushing Hazard (2)This safety message is positioned on both sides of the rear of the work tool.
g00943172
No clearance for person in this area during operation. Severe injury or death from crushing could occur. Stay away from the work tool while it is in operation.
Forks (3)This safety message is positioned on both sides of the work tool.
g01059274
Side loading of the forks may cause premature failure of the forks and thus a crush hazard which may cause personal injury or death. Never push loads with the forks and inspect the forks daily for any twisting or bending observed in the forks. Should twisting or bending be observed, change the fork(s) prior to any lifting operation. Read the Operation and Maintenance Manual for more information about the correct use of the forks.