DISPLAY GP- 2836377 - Caterpillar

Illustration 2 g00717809
Remove clips (4) and (8) .
Remove tube assemblies (5), (6), and (7) .
Illustration 3 g00717797
Disconnect three wires (9) .
Illustration 4 g00719194
Remove bolt (13) and the washer. Move clip (12), hose (14), clip (10), and wire harness (11) away from the engine.
Illustration 5 g00717849
Illustration 6 g00717851
Remove clip (15). Use Tooling (A) to slide sleeve (16) away from the governor and toward the cylinder head.
Install Tooling (B) into link pin (17) of the governor output shaft. When Tooling (B) is properly installed, equal lengths of the smaller end of Tooling (B) will extend from both ends of link pin (17) .
Install Tooling (C) onto the smaller end of Tooling (B) in order to help to align link pin (17) .
Illustration 7 g00717816
Remove tube assembly (18) .
Disconnect clip (21). Clip (21) secures the engine oil dipstick to pump (19) .
Remove bolts (20) and the washers. Carefully remove pump (19) so that the fuel control linkage is not damaged. Remove the O-ring seal on governor (20) .Installation Procedure
Illustration 8 g00717816
Install the O-ring seal on governor (19). Carefully install governor (19) so that the fuel control linkage is not damaged. Install the washers and bolts (20) .
Connect clip (21). Clip (21) secures the engine oil dipstick to the pump (19) .
Install tube assembly (18) .
Illustration 9 g00717851
Illustration 10 g00717849
Install Tooling (B) into link pin (17) of the governor output shaft. When Tooling (B) is properly installed, equal lengths of the smaller end of Tooling (B) will extend from both ends of link pin (17) .
Install Tooling (C) onto the smaller end of Tooling (B) in order to help to align link pin (17) .
Use Tooling (A) to slide sleeve (16) away from the cylinder head and toward the governor. Install clip (15) .
Illustration 11 g00719194
Move clip (12), hose (14), clip (10), and wire harness (11) into position. Install bolt (13) and the washer.
Illustration 12 g00717797
Connect three wires (9) .
Illustration 13 g00717809
Install tube assemblies (5), (6), and (7) .
Install clips (4) and (8) .
Illustration 14 g00717782
Connect throttle cable (1) .
Tighten nut (3) .
Install bolt (2), the nut and the washers.
Check the fuel setting adjustment.Reference: Refer to Systems Operation/Testing and Adjusting, SENR3583, "Basic Engine Components for 3114, 3116 and 3126 Engines" for the proper procedure.
Turn the battery disconnect switch to the OFF position and remove the key.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".