DISTRIBUTION AR 3967667 - Caterpillar

Introduction
Some of the components that are connected to the electronic control modules can be calibrated by using the Caterpillar Electronic Technician (Cat ET).Calibrations are performed when directed by troubleshooting procedures or replacing a component within the calibrated system.The calibration of a component allows the ECM to determine the correct output level. The calibration also allows the ECM to determine the correct input signal of displacement.For more information on error codes that may occur during calibration refer to Testing and Adjusting, UENR4633, "Calibration Error Codes".Required Tools
Illustration 1 g03142124
Table 1
Required Tools
Tool Item Qty Part
Number Description
C 1 317-7484(1) Communication Adapter Gp
C1 1 370-4617 Cable As (USB PC Communication)
C2 1 317-7485 Communication Adapter III
C3 1 327-8981 Cable As (Data Link)
C4 1 317-7492 Cable As Wireless Radio
C5 1 JERD2129 Caterpillar Electronic Technician (Cat ET)
(1) Cat Electronic Technician (ET) and Software CD, NETG5057 are required when using the communication adapter.Cat ET Calibration Screen
Illustration 2 g06071032
Calibration screen
Implement ECM Calibrations
The following calibrations can be performed to the Implement ECM:
Auxiliary Solenoid Calibrations
Solenoid Calibrations
Operator Input Calibrations
Cross-Slope Valve Calibrations
Cross-Slope Sensor CalibrationsTo access the calibration procedures for the Implement ECM, establish the connections of the Cat ET to the machine. Navigate to the calibration screen by clicking "Service" on the tool bar and then clicking "Calibrations". Select the desired calibration procedure that is required. Click on the "Start" button at the bottom of the screen.Once the specific calibration is selected, the Cat ET will guide you through the calibration procedure.The Cat ET will list initial machine conditions that must be