DOOR AS 1188081 - Caterpillar

Go to "Configuration", "DSS", "Peripherals", and click "Camera" to adjust the "Pitch" and "Yaw". Adjust by subtracting the value if the line falls below "0". If the line falls above "0", you add to the value until the line falls at "0".Note: Every values changed in the camera settings, you need to save and commit, the DSS will reboot and execute the settings inputted. You can verify your changes in the "Diagnostics" page.Post Installation Network Configuration check
Illustration 68 g06205930
Go to "Configuration", "Network Configuration", "Mobile Broadband". Ensure that the type is "GSM" and the input is Access Point Name "APN"" from your SIM card provider. "Roaming" should be checked.
"Save" changes.
Go to "Ethernet" category and verify "Never Use Default Route" is checked.Note: When using CDMA Modem, uncheck "Never Use Default Route".
"Save" and "Commit" changes.Configuring Driver Safety System with Multitech CDMA Modem
After inserting the SIM card into the router, and turning on the DSS unit, follow these steps:
Change the IP address to 192.168.2.10 and the "Gateway" should be 255.255.255.0
Ensure the DSS and the router are powered on and the blue Ethernet cable is plugged into the Ethernet port of the DSS and the router.
Open a browser, type http://192.168.2.1 in the address bar, press "Enter".Note: A warning page that the site is "untrusted", may appear. Click "Continue to this website (not recommended)".
Illustration 69 g06206691
Log in to the "Multitech" systems page.Note: Login name and password are both "admin" (all lower case).
Illustration 70 g06206694
Ensure "Network Router" is selected on the screen and click next.
Illustration 71 g06206696
Leave all fields blank and click "Skip".
Illustration 72 g06206928
Ensure the proper "Time" and "Date" is set in the Time Configuration screen then hit next.
Illustration 73 g06206991
Leave the "IP Setup" screen as is and click "Next".
Illustration 74 g06207276
Check "Enabled" only and click "Next" on the Cellular PPP configuration page.
Illustration 75 g06207283
Check the field and type "APN" if needed.Note: Applies to GSM only.
Illustration 76 g06207292
Select "None" and click "Finish" for PPP authentication.
Illustration 77 g06207295
Choose the "Save and Restart" from the menu on the left.
Illustration 78 g06207333
Click "OK" if prompted.
Illustration 79 g06207334
The router will reset.
Disconnect the blue Ethernet and reconnect to the DSS after the system resets.
Reset the DSS by unplugging and reconnecting the power cable.Note: Once the DSS powers back on, the DSS should have a network connection. Connection will be viewable in "Data Up Loader" screen, and connection light on the DSS unit will be green.