DOOR GP-CAB 1652649 - Caterpillar

b) If an adjustment is needed, loosen nut (11) about two turns. Make sure plate (12) is free on its stud. Turn the flywheel 180° and loosen the other nut and plate using the same procedure.c) Turn the adjusting ring (13) clockwise to increase or counterclockwise to decrease the pounds of force.9. Install the access cover over the flywheel on the flywheel housing.10. Install the inspection cover, lever and spring on the cover of the flywheel clutch. 11. Connect the two grease lines (14) to the flywheel clutch.12. Connect bracket (20) to the cover of the flywheel clutch.13. Install vent line (21). Connect vent line (19) for the transmission.14. Connect the four oil lines (18) to the hydraulic control mechanism.15. Install four rods (22), (23), (24) and (17) for the steering clutch controls and the brakes.16. Install crossmember (15) and seat frame support (16).17. Install the side panel over the hydraulic control valves for the bulldozer (if so equipped).18. Fill the flywheel clutch with oil to the correct level. See LUBRICATION AND MAINTENANCE GUIDE.end by:a) install crankcase guard (rear)b) install brake pedals and dashc) install universal jointd) install seat and seat frame assemblyDisassemble Flywheel Clutch (Direct Drive
start by:a) remove flywheel clutch 1. Remove the bolts and nuts (1) that hold the hydraulic control mechanism to the clutch cover. Disconnect the links (3) of the mechanism from the bellcrank lever. Remove the mechanism (2) from the clutch cover.2. Remove bolts (5) and the oil pump (4).3. Remove nuts (6) and the oil screen and cover as a unit (7). 4. Remove the nut (8), spring (9), screen (10), and gasket (11) from the cover (12).5. Remove bolt (16) and bellcrank lever (15). 6. Remove nuts (13) and brake lever (14). 7. Fasten a hoist to the clutch cover (18) and remove it. Make sure the blocks (17) move out of the actuating yokes in the clutch cover. Weight of the clutch cover is 125 lb. (57 kg). 8. Remove the locks (19), retainers (22), springs (21), and pins (20) from the pressure plate with tool (A). 9. Fasten a hoist to the bracket for the adjustment ring. Remove the bracket (23) from the pressure plate (24). 10. Turn the bracket for the adjustment ring over. Remove the bolts (25) and locks that hold the loading plate and hub to the bracket. Fasten a hoist to the bracket. Remove the loading plate (27) and bracket from the hub (26). 11. Remove the two bearings (28) from the hub with tooling (B). 12. Remove the twelve bushings that hold the adjustment plate (30) to the sliding collar (29). Remove the sliding collar.13. Remove the nuts (31), locks (32), and plates from the bracket. Remove the adjustment plate from the bracket by turning it counterclockwise. 14. Disassemble the sliding collar by removing the snap ring (36), collar assembly (35), washers (37) and collar (34) from the sleeve (33).15. Remove the snap ring (40), idler gear (42) for the oil pump, and washers