DOOR GP-ACCESS 2069380 - Caterpillar

Illustration 16 g00950071
(3) Retainer (12) Bolt (13) Washer
Remove bolts (12) and washers (13). Remove retainers (3) .
Illustration 17 g00950072
(B) Packing
Inspect packing (B). Clean the area around the packing. Inspect the packing and determine if the packing needs to be replaced. Signs for replacement of the packing would be the following conditions: damaged packing, debris under the packing and oil leakage through the packing. Leakage through the packing would indicate leakage of the Duo-cone seal group in the final drive. Refer to the service manual in order to replace the Duo-cone seal group. Replace the Packing
Table 6
Required Parts    
Machine     Qty (1)     Pt. No.     Description    
All     1     129-1928     Lubricant    
D10R     2     189-6244     Seal    
D10N     2     133-1124     Seal    
D10     2     137-9810     Seal    
D9R     2     189-6244     Seal    
D9N     2     133-1124     Seal    
D8R     2     137-9810     Seal    
D7R     2     137-9810     Seal    
D6R     2     137-9810     Seal    
( 1 ) This quantity is used to replace the packing for one seal guard.
Illustration 18 g00950072
(B) Packing
Remove the old packing (B) from the seal guard. Clean the seal guard in order to prepare for installation of the new packing.Note: Each final drive seal guard requires two seals. The sections of packing are installed on top of each other in the groove of the seal guard.
Illustration 19 g00950074
(1) Inner packing (C) Diameter (D) Joint in the inner packing
Install inner packing (1). Place a thin film of lubricant on diameter (C). Stretch the packing during installation. Smooth the packing and keep the packing uniform. Minimize the joint (D) at the ends of the inner packing (1) .
Illustration 20 g00950075
(2) Outer packing (C) Diameter (D) Joint in the inner packing (E) Joint in the outer packing (F) 180 degrees
Install the outer packing (2). Offset the joint in the inner packing (D) and the outer packing (E) by 180 degrees (F) . Stretch the packing during installation. Smooth the packing and keep the packing uniform. Minimize the joint (E) at the ends of the outer packing (2) .
Illustration 21 g00950077
(2) Outer packing (3) Retainer (12) Bolt (13) Washer (E) Joint in outer packing (G) 90 Degrees from joint in outer packing to joint in retainers (H) Joint in retainersNote: The joint (E) in the outer packing (2) must be offset 90 degrees (G) from joints (H) in retainers (3).
Illustration 22 g00950079
Cross section view of seal guard (1) Inner packing (2) Outer packing (3) Retainer (11) Seal guard (A) 2 mm (0.079 inch)
Assemble retainers (3) to seal guard (11) with sixteen washers (4) and sixteen bolts (5). The clearance at area (D) should be 2 mm (0.079 inch).
Replace the packing on the other final drive, if necessary.