DOOR AS-ACCESS 2734829 - Caterpillar

TARGET="_parent">Backup Alarm - Test
Cooling System Coolant Level - Check
Cutting Edges and End Bits - Inspect/Replace
Engine Oil Level - Check
Engine Water Pump - Inspect
Fuel System Primary Filter (Water Separator) - Check/Drain
Hydraulic System Oil Level - Check
Seat Belt - Inspect
Starting Motor - Inspect
Transmission Oil Level - Check
Every 50 Service Hours or Weekly
Axle Oscillation Bearings - Lubricate
Bulldozer Stabilizer - Lubricate
Cab Filter (Fresh Air) - Clean/Inspect/Replace
Cab Filter (Recirculation) - Clean/Inspect/Replace
Fuel Tank Water and Sediment - Drain
Lift Cylinder Upper Trunnion Bearing - Lubricate
Steering Cylinder Bearings - Lubricate
Tire Inflation - Check
Initial 250 Service Hours
Cooling System Coolant Sample (Level 2) - Obtain
Hydraulic System Oil Filter (Hydraulic Fan Return) - Replace
Transmission Oil Filter - Replace
Every 250 Service Hours
Engine Oil (High Speed) and Oil Filter - Change
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filters - Replace
Every 250 Service Hours or Monthly
Battery - Clean
Battery or Battery Cable - Inspect/Replace
Belts - Inspect/Adjust/Replace
Brake Accumulator - Check
Braking System - Test
Differential and Final Drive Oil Level - Check
Drive Shaft Spline (Center) - Lubricate
Engine Oil Sample - Obtain
Every 500 Service Hours or 3 Months
Cooling System Coolant Sample (Level 1) - Obtain
Differential and Final Drive Oil Sample - Obtain
Fuel Tank Cap and Strainer - Clean
Hydraulic System Oil Filter (Hydraulic Fan Return) - Replace
Hydraulic System Oil Filter (Steering and Implement Pilot) - Replace
Hydraulic System Oil Sample - Obtain
Transmission Oil Filter - Replace
Transmission Oil Sample - Obtain
Every 1000 Service Hours or 6 Months
Articulation Bearings - Lubricate
Battery Hold-Down - Tighten
Drive Shaft Support Bearing - Lubricate
Rollover Protective Structure (ROPS) - Inspect
Transmission Oil - Change
Every 2000 Service Hours or 1 Year
Axle Oil Cooler Filter - Replace
Cooling System Coolant Sample (Level 2) - Obtain
Crankshaft Vibration Damper - Inspect
Differential and Final Drive Oil - Change
Engine Mounts - Inspect
Hydraulic System Oil - Change
Hydraulic Tank Breaker Relief Valve - Clean
Receiver Dryer (Refrigerant) - Replace
Every 2500 Service Hours
Electronic Unit Injector - Inspect/Adjust
Engine Valve Lash - Check
Every 3 Years
Seat Belt - Replace
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change