DOOR AS-ACCESS 3753052 - Caterpillar

Full Torque Setting (FTS)
FTS is like FLS. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.Security Access Parameters
CAN Communication Protocol Write Security
Not AvailableCAN Communication Protocol Read Security
Not AvailableTotal Tattletale
The total tattletale counts the number of changes that are made to system configuration parameters. System Configuration Parameters
The system configuration parameters are listed in Table 2.
Table 2
System Configuration Parameters
Parameter Parameter Setting
ECM Identification Parameters
Equipment ID(1) 17 alphanumeric characters
Engine Serial Number(1) 0XX00000 or XXX00000
ECM Serial Number (2) Read Only
Software Group Part Number (2) Software Dependent
Software Group Release Date (2) Software Dependent
Software Group Description (2) Software Dependent
Selected Engine Rating
Rated Power (2) Software Dependent
Rated Peak Torque (2) Software Dependent
Speed Control
Low Idle Speed 700 rpm
High Idle Speed (773G and 775G Engines only) 2050 rpm
High Idle Speed (777G Engines only) 2200 rpm
Engine Configuration Parameters
Ether Solenoid Configuration (1) Configured at the Factory
Engine Retarder Enable Command Configured at the Factory
Low System Battery Voltage Elevated Idle Enabled
Engine Warmup Elevated Idle Feature Enable Status Enabled
Engine Idle Shutdown
Engine Idle Shutdown Minimum Ambient Air Temperature 0° C (32° F)
Engine Idle Shutdown Maximum Ambient Air Temperature 30° C (86° F)
Engine Idle Shutdown Enable Status Enabled
Engine Idle Shutdown Delay Time 5.0 min
Engine Idle Shutdown Ambient Temperature Override Enable Status Enabled
Delayed Engine Shutdown
Delayed Engine Shutdown Enable Status Enabled
Delayed Engine Shutdown Maximum Time 5.0 min
Aftertreatment Configuration
Factory Installed Aftertreatment #1 Identification Number Hardware Dependent
System Settings
FLS (Full Load Setting) (1) Programmed at the factory
FTS (Full Torque Setting) (1) Programmed at the factory
Security Access Parameters
CAN Communication Protocol Write Security Seed and Key Access
CAN Communication Protocol Read Security Seed and Key Access
Total Tattletale Read Only
(1) The parameter must be reprogrammed if the ECM is replaced.
(2) These parameters cannot be changed.Parameter Worksheet
Use the following worksheet to record the parameters that are specific to your engine.
Table 3
System Configuration Parameters
Parameter Parameter Setting
ECM Identification Parameters
Equipment ID
Engine Serial Number
ECM Serial Number
Software Group Part Number
Software Group Release Date
Software Group Description
Selected Engine Rating
Rated Power
Rated Peak Torque
Speed Control
Low Idle Speed
High Idle Speed
Engine Configuration Parameters
Ether Solenoid Configuration
Engine Retarder Enable Command
Low System Battery Voltage Elevated Idle
Engine Warmup Elevated Idle Feature Enable Status
Engine Idle Shutdown
Engine Idle Shutdown Minimum Ambient Air Temperature
Engine Idle Shutdown Maximum Ambient Air Temperature
Engine Idle Shutdown Enable Status
Engine Idle Shutdown Delay Time
Engine Idle Shutdown Ambient Temperature Override Enable Status
Delayed Engine Shutdown
Delayed Engine Shutdown Enable Status
Delayed Engine Shutdown Maximum Time
Aftertreatment Configuration
Factory Installed Aftertreatment #1 Identification Number
System Settings
FLS (Full Load Setting)
FTS (Full Torque Setting)
Security Access Parameters
CAN Communication Protocol Write Security
CAN Communication Protocol Read Security
Total Tattletale