DOOR GP-ACCESS 5566475 - Caterpillar

Key Help Menus and Functions
Table 1
CTRL Help Menu    
CTRL-\     Show bypass available status    
CTRL-A     Send Telemetry Limits To CS View    
CTRL-B     Enter Bypass (Maintenance) Mode    
CTRL-C     Resend Calibration Prompt to UPS View    
CTRL-D     Download the Event Log    
CTRL-G     Dump Skiip currents from FPGA    
CTRL-H     Help Menu    
CTRL-J     Report current diagnostic information    
CTRL-L     Toggle Discharge Disable    
CTRL-M     Enter Manual Mode    
CTRL-N     Revision History    
CTRL-O     Enter Online Mode    
CTRL-P     Clear Password Enables    
CTRL-Q     Reset Modem NVRAM    
CTRL-R     Reset The Microprocessor    
CTRL-S     Enter Bypass Mode Spin-down State    
CTRL-V     Disable Vacuum shutdowns    
CTRL-W     Toggle Modem Off-hook / On-hook    
CTRL-X (1) (2) (3)     Brake the rotor to zero speed    
CTRL-Y     Dump Modem configuration    
CTRL-Z     Dump Setpoints to Screen    
CTRL-[     Manual GSC Start    
CTRL-]     Manual GSC Stop    
ALT-H     ALT Key Help Menu    
( 1 ) 7700 RPM to 20 RPM in 15 minutes
( 2 ) This function is only allowed once every 24 hours due to armature heating
( 3 ) The PC must be connnected. The keyswitch on the MMU must be in the "Online" postion.
Table 2
ALT Help Menu    
ALT-A     Clear Static Switch Enable    
ALT-C     Send system Calibration Factors over CAN    
ALT-D     AVR Demand FPGA reading    
ALT-E     Ethernet Loopback Test    
ALT-F     Force Op. Params on other MMUs    
ALT-H     ALT Key Help Menu    
ALT-I     EPO Switch statuses    
ALT-J     Report current ethernet diagnostic information    
ALT-L     Synchronize Event Logs    
ALT-M     Show MMU status registers    
ALT-N     Toggle Notification debug msgs    
ALT-O     Toggle Op. Param match over CAN.    
ALT-P     Cancel current page.    
ALT-R     Regulation Only Mode    
ALT-S     Enter AVR Mode Spin-down State    
ALT-T     Show Telemetry and Status Registers    
ALT-V     Verify PCC serial flash configuration page    
ALT-W     Toggle Discharge Walk-in to Input Voltage    
ALT-Z     Parameter List that is not Default Parameters