DOWEL 0676002 - Caterpillar

By using the hand triggers on each side of the windshield, unlatch the windshield from the front strikers and pull the windshield upward. Tilt the windshield to an angle in order to remove the windshield from the front tracks.
Illustration 5 g01093852
Front striker
If necessary, the front strikers can be removed from each side of the cab. Remove the front strikers by removing three bolts (5) .
Illustration 6 g01093858
Top switch
The front striker that is located in the top right hand corner of the cab contains windshield wiper switch (6). If necessary, remove the switch by loosening the hex nut and removing two wires (7) .
Illustration 7 g01089922
Bottom switch
Windshield wiper switch (8) is located on a bracket along the right hand side of the cab. If necessary, remove the switch and the bracket by removing the mounting bolt for the bracket. Disconnect wires (9) for the switch.Installation of the Front Windshield and Switches
Illustration 8 g01089922
Bottom switch
If necessary, install windshield wiper switch (8) on the bracket. Install the bracket on the cab and torque the bolt to 12 3 N m (8.9 2.2 lb ft). Reconnect wires (9) for the switch and tighten the hex nut in order to secure the switch in position.Note: Adjust the switch for proper activation after the bottom window is installed.
Illustration 9 g01093858
Top switch
If necessary, install windshield wiper switch (6) in the front striker that is for the top right hand corner of the cab. Install two wires (7) for the switch and tighten the hex nut in order to secure the switch in position.
Illustration 10 g01093852
Front striker
If necessary, position the front strikers on both sides of the cab and install three bolts (5). Torque the bolts to 12 3 N m (8.9 2.2 lb ft).
Illustration 11 g01089929
Hand trigger for top window
Place the bottom rollers of the windshield into the front tracks and push the windshield into position. Use the hand triggers on each side to lock the windshield into the front strikers.
Illustration 12 g01089926
Top track and spacers
Position top tracks (2) on each side of the cab. Install four bolts (3) through the top tracks. Add spacers (4) between the cab and the top tracks and torque the bolts to 2.25 0.25 N m (1.660 0.184 lb ft).
Remove the pins from the roller supports and open the windshield. Refer to ""Adjustment of the Top Tracks"" and ""Adjustment of the Rear Strikers"" for more information.Adjustment of the Top Tracks
Illustration 13 g01093078
Distance between top tracksAdjustment of the top tracks for the windshield