DOWEL 2109587 - Caterpillar

Insert the appropriate pins from the Harness As. (1) into the Receptacle As. (2). The pins are labeled in accordance with the configuration Table 3.
Table 3
Work Tool Electrical Connector Configuration (Pin Outs)
14–Pin Position(1) Machine Signal Wire Label-Wire Number Wire Color
A LH Joystick Trigger (AUX 7) "A-WT1" Purple
B Ground "B-WT2" Black
C RH Joystick "C-" (AUX 3) "C-WT3" Orange
D RH Joystick "C+" (AUX 4) "D-WT4" Brown
E LH Joystick "C2" (AUX 5) "E-WT5" Gray
F LH Joystick "C1" (AUX 5) "F-WT6" Blue
G Unused "F-WT7" White
H Unused "G-WT8" White
J Cab Rocker Switch (AUX 8) "H-WT9" Pink
K Unused "K-WT10" Blue
L Unused "L-WT11" White
M XHP High Flow WT Present Signal "M-WT12" White
N Unused "N-WT13" Green
P Unused "P-WT15" White
(1) Machine Side
Illustration 2 g06123877
Left-hand joystick work tool electrical controls
(A) aux 7 Pin A
(E) "C2"aux 5 Pin E
(F) "C1"aux 6 Pin F
Illustration 3 g06123885
Right-hand joystick work tool electrical controls
(C) "C+"aux 4 Pin C
(D) "C-"aux 3 Pin D
Illustration 4 g06123870
Cab upper left-hand switch panel
(J) aux 8 Pin J
Illustration 5 g06123890
Work tool electrical connector - socket identification
Refer to Illustrations 2, 3, 4, and 5 to identify the available machine electrical output controls.
Remove the wire labels & position the Sleeve (3) near the Receptacle As. (2) and tighten the screws of the cable clamp securely, capturing the sleeve.
Further secure the Sleeve (3) with the Cable Strap (4) at the loose end of the sleeve and midpoint and clip the excess strap material.
Install the jumper harness between the host machine work tool electrical connector and the work tool harness electrical connector.Refer to the machine and work tool Operation and Maintenance Manuals for complete operation & safety information before operating the work tool.