DOWEL 2932141 - Caterpillar

Illustration 1 g01225069
Schematic of the Machine Autolube Pressure Sensor
This diagnostic code is associated with the machine autolube pressure sensor. The FMI 04 means that the ECM has determined that the voltage of the circuit for the position sensor is below normal. The position sensor is a PWM sensor that operates at a frequency of approximately 500 hertz. The possible causes of this diagnostic code are listed below:
The signal circuit for the sensor is shorted to ground.
The sensor has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0379 FMI 04 is active before performing this procedure. Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. INSPECT THE SENSOR.
Perform a visual inspection of the sensor, the wiring for the sensor and the hardware that is associated with the sensor. Expected Result:There is no apparent damage to the sensor, the wiring for the sensor or the hardware that is associated with the sensor.Results:
OK - There is no apparent damage to the sensor, the wiring for the sensor or the hardware that is associated with the sensor. Proceed to Test Step 3.
NOT OK - There is apparent damage to the sensor, the wiring for the sensor or the hardware that is associated with the sensor. Repair: Replace the damaged part.Proceed to Test Step 2.Test Step 2. CHECK THE ADJUSTMENT AND/OR THE CALIBRATION OF THE SENSOR.
Turn the disconnect switch and the key start switch to the ON position.
Perform the calibration of the position sensor.
Check the status of the diagnostic code. Expected Result:The CID 0379 FMI 04 is not active.Results:
OK - The diagnostic is not active. The adjustment and/or the calibration has corrected the failure. Resume normal operation.STOP
NOT OK - CID 0379 FMI 04 is still active. Exit the calibration procedure. Proceed to Test Step 3.Test Step 3. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along contact A (wire C985-BU(Blue)) for the voltage supply.
Turn the key start switch and the disconnect switch to the ON position.
Measure the voltage from contact A (wire C985-BU(Blue)) to contact B (wire 202-BK(Black)). Expected Result:The voltage is 8 DCV.Results:
OK - The voltage is 8 DCV. Proceed to Test Step 4.
NOT OK - The voltage is NOT 8 DCV. The circuit is open. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 4. CHECK THE SIGNAL OF THE SENSOR.
Turn the key start switch and the disconnect switch to the OFF position.
The 7X-1710 Multimeter Probe remains along contact B (wire 202-BK(Black)).
At the back of the harness connector for the sensor, insert the other 7X-1710 Multimeter Probe along contact C (wire C532-GN(Green)).
Turn the disconnect switch and the key start switch to the ON position.
Monitor the signal of