DOWEL 3F6808 - Caterpillar

Never disconnect any charging unit circuit or battery circuit cable from the battery when the charging unit is operating. A spark may cause the combustible gases that are produced by some batteries to ignite.Connect the negative jump-start cable last from the external power source to the negative terminal of the starting motor. This connection sequence helps to prevent sparks from igniting any combustible gasses which batteries may produce. If the starting motor is not equipped with a negative terminal, connect the jump-start cable to the engine block.Check the electrical wires daily for wires that are loose or frayed. Tighten all loose electrical wires before the engine is operated. Repair all frayed electrical wires before the engine is started. See this Operation and Maintenance Manual, "Engine Starting" for specific starting instructions.Grounding Practices
Properly ground the electrical system for the vessel and the engine. Proper grounding is necessary for optimum engine performance and reliability. Improper grounding will result in uncontrolled or unreliable electrical circuit paths.Uncontrolled or unreliable electrical circuit paths may result in damage to main bearings, crankshaft bearing journal surfaces, and aluminum components. Uncontrolled electrical circuit paths may also cause electrical noise. Electrical noise may degrade the performance of the vessel and of the radio.Connect the starting motor directly to the negative battery terminal. Connect the alternator to the negative battery or negative terminal for the starting motor. The alternator and the starting motor must meet marine isolation requirements.Note: All electrical connections must meet or exceed the American Boat and Yacht Council Standard E-11.Use a bus bar with a direct path to the negative battery terminal for low current components that require a negative battery connection. Connect the bus bar directly to the negative battery terminal.Note: All return paths to the negative battery must be able to carry fault currents.The use of a bus bar ensures that the electronic control module (ECM) and the components connected to the ECM have a common reference point.Refer to Special Instruction, REHS1187, "Marine Engine Electronic Installation Guide" for additional information on grounding procedures.Refer to Application and Installation Guide, LEBM0001-01, "Marine Engine Electronics C7 - C32" for additional information on grounding procedures.Negative Battery Connection for Multiple Engines
Illustration 1 g03324810
(1) Engines
(2) Parallel switch
(3) Customer miscellaneous vessel loads
(4) Overcurrent protection
(5) Battery
(6) Battery disconnect switches
(7) Battery
(8) Direct current (DC) main negative bus bar
(9) Alternating current (AC) grounding bus bar
(10) Strainer
(11) Cathodic protection bus bar
(12) Lightening protection ground point
(13) Immersed ground plate
(14) Zinc bar
(15) Electronics ground plate
(16) Chain plates
(17) Grounding bus bar
(18) Engine negative terminal
(19) BatteryInstall the battery disconnect switches as close as possible to the battery positive (+) but outside of the battery enclosure.Note: If multiple bus bars are used to connect components to the negative battery, a common reference should be provided. All bus bars must be wired together for proper engine synchronization for multiple engine operations.