DOWEL 6D3036 - Caterpillar

Specifications
Table 1
Parameter Value
Fuel Supply Pressure 483 to 1724 kPa (70 to 250 psi)
Fuel Pressure to Fuel Metering Valve 448 34 kPa (65 5 psi)(1)
(1) The fuel pressure must be stable to 1.7 kPa ( .25 psi).Introduction
Use this procedure to check the regulated gas pressure. Make sure that the fuel supply pressure is correct.Required Tools
Table 2
Required Tools Qty
1U-5470 Engine Pressure Gp 1
8T-5160 Gas Regulator Setting Tool 1
Illustration 1 g01192577
1U-5470 Engine Pressure Group
(1) Pressure indicators
(2) Zero adjustment screw
(3) Pressure indicator
(4) Pressure tap
(5) Pressure indicator This tool group has an indicator that is used to read the pressure in the gas lines. The Special Instruction, SEHS8907 is with the tool group.Test Preparation - Fuel Pressure to Fuel Metering Valve
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Illustration 2 g03812411
TecJet Valve
(6) Fuel metering valve
(7) Gas pressure sensor
(8) Gas line
(9) Gas Shutoff Valve (GSOV)
Illustration 3 g03812413
F-Series valve
(6) Fuel metering valve
(7) Gas pressure sensor
(8) Gas line
(9) Gas Shutoff Valve (GSOV)
(10) Plug
Turn off the main gas valve.
De-energize the Gas Shutoff Valve (GSOV).
Slowly remove gas pressure sensor (7) from gas line (8). Note: The port for plug (10) on the G3616 models can be used instead of the port for gas pressure sensor (7).
Install a fitting into gas line (8). Connect the 1U-5470 Engine Pressure Gp to the fitting. Refer to Illustration 1. Test Procedure - Fuel Pressure to Fuel Metering Valve
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Open the main gas valve.
Energize the GSOV.
Check the engine gas pressure to the engine. If, the pressure is not 448 34 kPa (65 5 psi) refer to Adjustment Procedure - Fuel Pressure to Fuel Metering Valve. Adjustment Procedure - Fuel Pressure to Fuel Metering Valve
Illustration 4 g03817966
(11) Bolt
(12) Cover
Remove cover (12), and install the correct tools, from the 8T-5160 Gas Regulator Setting Tool, for pressure setting adjustment.
Adjust bolt (11) to achieve desired fuel pressure to the fuel metering valve.
After desired pressure is reached, install cap (12).