DOWEL 6V7951 - Caterpillar

Typical example of an error message for the reverse fan functionReverse Fan Function Will Not Start
The monitor will provide one of the following error messages if the reverse fan function does not start:"NOT INSTALLED" - The reverse fan is not installed on this machine. If this message is received in error, consult your Caterpillar dealer."HYD OIL TEMP HIGH" - The hydraulic oil temperature is too high. Shut off the engine and do not operate the machine until the hydraulic oil temperature is below 85 °C (185 °F)."COOLANT TEMP HIGH" - The coolant temperature is too high. Shut off the engine and do not operate the machine until the coolant temperature is below 95 °C (203 °F)."HYD LOCK SW OFF" - The hydraulic lockout control is in the UNLOCKED position. Move the hydraulic lockout control to the LOCKED position."SOL MALFUNCTION" - The reverse fan is malfunctioning. Consult your Caterpillar dealer.Reverse Fan Function Is Interrupted
If one of the following conditions occur, the reverse fan function will stop, and regular operation of the radiator cooling fan will resume:
The hydraulic lockout control is moved to the UNLOCKED position.
The temperature of the hydraulic oil rises above 90 °C (194 °F).
The coolant temperature rises above 100 °C (212 °F).This event will be accompanied by a "REVERSE FAN ERROR" message.Filter and Fluid Information
The "FLTR/FLUID INFO" menu allows the operator to change the accumulated hours for the machine's filters and fluids.
Press the menu key.
Table 51
"MAIN MENU"
"SERVICE"
Press the right key or press the left key in order to highlight the "SERVICE" menu. Press the OK key. Note: You will be prompted to enter a password. Refer to "Password Entry" for information on entering a password.
Table 52
"SERVICE"
"MAINTENANCE"
"PASSWORD CHANGE"
After the password has been entered successfully, press the up key or the down key in order to highlight the "MAINTENANCE" menu. Press the OK key.
Table 53
"MAINTENANCE"
"REVERSE FAN"
"FLTR/FLUID INFO"
Press the up key or the down key in order to highlight the "FLTR/FLUID INFO" menu. Press the OK key.
Table 54
"FLTR/FLUID INFO"
"ENGINE OIL FILTER"
"00000 / 00000 [HR]"
"HYD OIL RET FILTER"
"00000 / 00000 [HR]"
"PILOT OIL FILTER"
"00000 / 00000 [HR]"
A list of filters and fluids will be displayed. For each item, the current hours of use will be displayed on the left. The recommended change interval will be displayed on the right. Press the up key or the down key in order to highlight the desired filter or fluid. Press the OK key.
Press the left key in order to reset the accumulated hours for the selected item.
Press the OK key in order to save the new hours in memory. Note: Press the back key in order to return to the previous display without saving the value.Note: Press the home key in order to return to the default display.