DOWEL 8K0589 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     185-3630     Strap Wrench As     1    
C     1P-0510     Driver Gp     1    
D     207-1601     Rubber Lubricant     1    
E     7N-8268     Installation Tool     1    
F     9S-7354     Torque Wrench Gp     1    
Illustration 1 g03771583
Cutaway view of bearing housing to show lip seal orientation.
Lubricate outer diameter of lip seal (20) with Tooling (D). Using Tooling (C), install lip seal (20) into bearing housing (13) seal face down.
Illustration 2 g03771662
Note: The inner race of the lower bearing will be installed onto the shaft separate from the outer race and roller assembly. Only the outer race and roller assembly is to be installed into the bearing housing.
Using Tooling (C) and a suitable press, install outer bearing race and roller assembly (19) into the bearing housing.
Illustration 3 g03771898
Raise the temperature of inner lower bearing race (16). Slide inner lower bearing race (16) onto shaft (15) until inner lower bearing race (16) comes to rest against the shoulder of shaft (15) .
Illustration 4 g03772316
Install bearing (14) onto shaft (15). Install retaining ring (11) .
Illustration 5 g03772477
Using a suitable press, install shaft and bearing assembly (12) into bearing housing (13) .
Illustration 6 g03772478
Install retaining ring (10) in the orientation as shown in Illustration 6 to ensure that the oil drain hole is not blocked.
Illustration 7 g03772483
Using a suitable press, install seal collar (17) against the inner race of the lower bearing. Install O-ring seal (18) .
Illustration 8 g03772904
Align the marks and install shaft and bearing housing assembly (7) to impeller housing (6) .
Illustration 9 g03773970
Install a 0.25 mm (0.009 inch) shim between the bearing housing and the impeller housing at each bolt location. Install bolts (5) finger tight until flush with the bearing housing, then tighten