DOWEL 9S1307 - Caterpillar

Illustration 1 g06313440
Table 1
Item Qty Part Specification description
1 1 480-6738 Trunnion Support Inside diameter is 483.30 0.10 mm (19.027 0.004 inch).
2 3 164-4180 Plug As Torque to 210 20 N m (155 15 lb ft).
Before assembly, lubricate (seal, shaft or bore) lightly with lubricant that being sealed.
3 1 480-6737 Trunnion Support Inside diameter is 483.30 0.10 mm (19.027 0.004 inch).
4 2 9F-2167 Purge Screw Torque to 11 4 N m (97 35 lb in).
5 2 110-2446 Adapter Torque to 70 7 N m (52 5 lb ft).
6 2 3K-0360 O-Ring Seal Before assembly, lubricate (seal, shaft, or bore) lightly with lubricant that being sealed.
7 36 463-6062 Bolt Torque to 900 100 N m (664 74 lb ft).
8 24 463-6062 Bolt Use the following procedure to tighten bolts:
1. Tighten bolts clockwise or anti clockwise 375 40 N m (277 30 lb ft).
2. Again tighten bolts clockwise or anti clockwise 375 40 N m (277 30 lb ft).
3. Turn an additional 120 10 degrees.
4. Do not reuse torque turned bolts.
9 1 480-6736 Trunnion Outside diameter is 465.00 0.05 mm (18.307 0.001 inch).
10 - - Before assembly, apply blue Loctite 5188 on mating surfaces.
Before assembly, surfaces must be clean and free of burrs.
11 90 7X-2585 Bolt(1) Torque the bolts using alternating sequence to 1400 175 N m (1032 129 lb ft) and then turn an additional 120 10 degrees.
12 1 173-0562 Drain Assembly Tighten the assembly to 210 20 N m (155 15 lb ft).
Tighten the plug to 80 7 N m (59 5 lb ft).
13 1 6V-7660 O-Ring Seal Before assembly, lubricate (seal, shaft, or bore) lightly with lubricant that being sealed.
14 1 6V-3298 Magnetic Plug Torque to 210 20 N m (155 15 lb ft).
15 1 2S-4078 O-Ring Seal Before assembly, lubricate (seal, shaft, or bore) lightly with lubricant that being sealed.
16 2 419-6348 Bushing Outside diameter of the sleeve bearing is 483.93 0.16 mm (19.052 0.006 inch).
17 3 420-0648 Wiper Seal Before assembly, lubricate (seal, shaft, or bore) lightly with lubricant that being sealed.
18 24 8C-3411 Bolt(1) Torque to 875 125 N m (645 92 lb ft) and then turn an additional 120 10 degrees.
19 1 9M-5892 O-Ring Seal Before assembly, lubricate (seal, shaft, or bore) lightly with lubricant that being sealed.
(1) Do not reuse torque turned bolts