DOZER AS 1545063 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
B     1P-0520     Bearing and Seal Driver     1    
Illustration 1 g01197071
(X) Bucket control linkage (Y) Bearing
Lower the temperature of the sleeve bearing. Use Tooling (B) to install the sleeve bearing in the linkage. Install the sleeve bearing until Dimension (Z) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the linkage assembly.
Illustration 2 g00605192
Use Tooling (B) in order to install lip seal (3). Install lip seal (3) with the sealing lip toward the outside of the linkage. Install lip seal (3) until lip seal (3) makes contact with the bearing.
Repeat Steps 1 and 2 in order to install the lip seal and the bearing on the other side of the linkage assembly.
Illustration 3 g01197072
(X) Bucket control linkage (Y) Bearing
Lower the temperature of the sleeve bearing. Use Tooling (B) in order to install the sleeve bearing. Install the sleeve bearing until Dimension (Z) is 9.5 0.8 mm (0.37 0.03 inch) below the outside surface of the linkage assembly.
Illustration 4 g00870959
Use Tooling (B) in order to install two lip seals (2). Install lip seals (2) with the sealing lip toward the outside of the linkage. Install lip seals (2) until lip seals (2) make contact with the bearing.
Repeat Steps 4 and 5 in order to install the lip seals and the bearing on the other side of the linkage assembly.
Illustration 5 g01197075
(X) Stick (Y) Bearing
Lower the temperature of the sleeve bearing. Use Tooling (B) to install the sleeve bearing in the stick. Install the sleeve bearing until Dimension (Z) is 9.5 .8 mm (0.37 0.03 inch)below the outside surface of the stick.
Illustration 6 g00604197
Use Tooling (B) to install lip seal (1). Install lip seal (1) with the sealing lip toward the outside of the stick. Install lip seal (1) until lip seal (1) makes contact with the bearing.
Repeat Steps 7 and 8 in order to install the seal and the bearing on the other side of the stick.End By: Install the bucket control linkage. Refer to Disassembly and Assembly, "Bucket Linkage - Install".