DRAIN GP-ECOLOGY 1434953 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01944561
Install new seals (26) on manifold (27) .
Illustration 2 g00676889
Illustration 3 g00676902
Use a suitable lifting device to install aftercooler housing (23) on the manifold.
Install bolts (24) .Note: Three of bolts (24) have a washer with rubber seal (25) .
Illustration 4 g00676878
Check O-ring seals (22) for damage or wear. Replace the O-ring seals, if necessary.Note: Apply a light coat of lubricant to the O-ring seals prior to installation.
Install new gaskets (21) and the core assembly in aftercooler housing (19) .
Illustration 5 g00676871
Illustration 6 g01944694
Attach a suitable lifting device to the core assembly and aftercooler housing (19) . The weight of the core assembly and aftercooler housing (19) is approximately 41 kg (90 lb).
Install the core assembly and aftercooler housing (19) .
Install bolts (18) and bolt (20) .
Tighten the bolts in a numerical sequence to a torque of 28 7 N m (21 5 lb ft). Tighten the bolts again in a numerical sequence to a torque of 28 7 N m (21 5 lb ft).
Illustration 7 g00676821
Install flange (17) .
Illustration 8 g00676800
Install tube (14) .
Install bolts (13) .
Slide hose (15) in order to connect with the heat exchanger.
Tighten clamps (16) .
Connect tube (12) at both ends.
Illustration 9 g00676792
Install tube (10) .
Tighten clamp (11) .
Illustration 10 g00676788
Install bolt (9) (not shown).
Connect harness assemblies (8) .
Illustration 11 g00676782
Install filter (5) and tighten clamp (4) .
Install spacers (7) .
Install bolts (6) .
Install bolts (3) .
Connect tube (1) at both ends.
Install bolts (2) .
Fill the cooling system with coolant to the correct level. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".