DRAIN GP-COOLANT 2992382 - Caterpillar

Illustration 6.0 1. Tube assembly2. Hose assembly3. Support assembly37. Install the left side tube assembly (3) Illustration 7.0 from the valve (relief) to the main control pump38. Install the right side tube assembly from the valve (ball) to the main control pump.39. Install hose assembly connecting right (ball) and left (relief) valves40. Install hose assembly connecting the hammer drain tube assembly and the right side valve.
Illustration 7.0 1. Check Valve2. Tube assembly connects to (2) Illustration 6.03. Left side tube assembly to valve (relief) at boom foot.4. To right side valve (ball) at boom foot.41. Determine which boom and stick the machine is equipped with and refer to the appropriate line art and parts consist in the parts section of this book. Welding may be required to attach the stick lines mounting brackets. Refer to the "Welding Instructions" in this section.42. Install the "Boom Lines Groups" Auxiliary, Rotate (if equipped) and Drain.43. Install the "Stick Lines Groups" Auxiliary, Rotate (if equipped) and Drain. Rotate (if equipped)44. Starting at the rear of the machine, install the pump drive-gp, rotate pump and suction hose from the hydraulic tank.45. Mount the rotate valve bracket and the rotate valve. Welding may be required to mount the rotate valve bracket. Refer to the "Welding Instructions" in this section.46. Connect the rotate valve to the rotate pump with the appropriate hoses and hardware. Refer to the "Lines Group-Rotate" in the parts section of this book for the line art and parts consist.47. Install the hoses from the rotate valve to the boom foot area.48. Install the hoses that connect the boom foot to the boom for the Auxiliary, Rotate and Drain lines.49. Install the hoses that connect the boom and stick for the Auxiliary, Rotate and Drain lines.50. See the "Test and Adjust" section in this book for instruction on the Rotate, Auxiliary circuit and Speed Control.51. Install the new "Control Group - Hand". Refer to the "Joystick Installation Procedure" page in this section. This step may be performed last. Refer to the parts section for the line art and parts consist. The new wire connections for the joysticks must be soldered. See the "Control Group - Hand" parts page for further reference.
Position #2 for wiring harness installation. Illus. 852 Refill the hydraulic tank. See "Release Of Air From Main Pumps" in the System Operation section of the kit Owners Manual before starting the engine after draining the hydraulic tank.53. Position the machine like illustration #8 for the Wiring harnesses installation.54. Install the "Mounting Group - Control Auxiliary" behind the cab and make the harness connections. Refer to the parts section for the line art and parts consist. Additional harness routing and connector information is below.55. Remove air filter assembly and remove bracket.56. Drill holes in bracket to mount controller.57. Mount the controller.
Aurora built 8 pin connections. Illustration 9.0
AN harness, AP harness and the rotate harness connected by the relay panel in the battery compartment.58. Install relay panel. Aurora built with Rotate Function:Make these