DRAWBAR GROUP 5R7067 - Caterpillar

1. Remove cable tie (2) and disconnect electrical connector (1). 2. Disconnect hose assemblies (3) and (6) from vibratory motor (4). Cap and plug immediately.3. Remove four nuts (5) and the washers. Pull the vibratory motor from the drum, and remove the four bolts and Washers (not shown) that fasten the vibratory motor to the drive shaft. Remove vibratory motor (4) from the machine. For installation of the vibratory motor, reverse the removal steps.Disassemble & Assemble Vibratory Motor
Start By:a. remove vibratory motor 1. Remove bolt (3) and washer (2), and remove plate (1) and the coupling from the shaft. 2. Remove four bolts (8) and the washers, and remove coupling (6) from plate (1).3. Remove magnetic pickup (4) and the spacer from plate (5).4. Remove two bolts (7), the washers and the nuts, and remove plate (5) from the housing. 5. Remove four bolts (9), and remove end cap (10) from the housing. For correct assembly, note the orientation of openings in port plate (11) and end plate (10) before removing the port plate from the end cap.6. Remove port plate (11) and dowel (13) from end cap (10).7. If necessary, remove bearing (12) from the end cap. 8. Remove O-ring seal (14) and two dowels (15) from housing (18).9. Hold cylinder block (17) on shaft (16). Turn the housing over, and separate the housing and shaft from cylinder block (17) and the pistons. 10. Remove plate (19) and nine pistons (20) from cylinder block (17). 11. Remove nine pistons (20) from plate (19). For correct assembly, note the orientation of washers (22) and (23) when removing them from the balljoint and cylinder block.12. Remove balljoint (21) and washers (22) and (23) from cylinder block (17). 13. Remove swashplate (25) from the housing.14. Use Tool (A) to remove retaining ring (24) from shaft (16). 15. Use Tool (B) to remove retaining ring (26). Remove backup plate (27) and oil seal (28) from the housing.16. Remove shaft (16) from housing (18). Remove spacer (31) from the shaft.17. Use Tool (B) to remove retaining ring (29), and remove bearing (30) from the housing. Make sure all the motor parts are clean and free of all dirt and foreign material. Check all parts for damage or wear. Lubricate all moving parts with clean hydraulic system oil at the time of assembly. For assembly of the vibratory motor, reverse the disassembly steps.