DRIVE GP-FINAL 1043145 - Caterpillar

Removal Procedure
Start By:
Remove the fuel injection pump.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03348107
Remove nuts (1) and nut (3). Remove plate (4) and bracket assembly (2).
Illustration 2 g03348110
Remove bolts (5) and studs (6).
Remove connectors (7) and the O-ring seals.Installation Procedure
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Install the fuel transfer pump in the reverse order.
Torque bolts (5) and studs (6) to a torque of 30 4 N m (22 3 lb ft).