DRIVE GP-SWING 1141348 - Caterpillar

Removal Procedure
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Open the engine enclosure.
Illustration 1 g01182745
Remove screws (3) and harness assemblies (2) from offset valve (1) .
Disconnect hose assemblies (5) from offset valve (1) .
Remove bolts (4) and offset valve (1) from the machine.Disassembly and Assembly Information
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0808     Multipurpose Grease     1    
B     195-4609     Seal Pick     1    
Illustration 2 g01191826
(1) Lubricate sealing lips with a thin covering of the lubricant that is being sealed.Note: Apply Tooling (A) to the threads.Installation Procedure
Illustration 3 g01182745
Install offset valve (1) and bolts (4) on the machine.
Connect hose assemblies (5) on offset valve (1) .
Install harness assemblies (2) and screws (3) on offset valve (1) .
Close the engine enclosure.