DRIVE GP-FAN 1260563 - Caterpillar

Illustration 1 g00764894
Note: Assemble this linkage on the machine by rotating the rod end of the bucket cylinder and by positioning the grease fitting away from the stick. Coat all the bores for pins with lubricant. (1) 087-5845 Pin Diameter after plating ... 79.85 0.04 mm (3.144 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch)Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (2) 137-2919 Bearing Quantity ... 2 Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Inside diameter ... 80.25 + 0.085 - 0.000 mm (3.159 + 0.0033 - 0.0000 inch) Install the bearing in the bearing bore. ... 7.2 0.8 mm (0.28 0.03 inch) (3) 166-1486 Shim thickness ... 2.0 mm (0.08 inch)Note: Locate the above shim next to the power link. (4) Lubricate the sealing lip slightly with the lubricant that is being sealed. (5) 126-9461 Pin Diameter after plating ... 69.85 0.04 mm (2.750 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (6) Two 108-0979 Pins Diameter after plating ... 79.85 0.04 mm (3.144 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (7) 143-3841 Bearing Quantity ... 2 Outside diameter ... 95.18 0.013 mm (3.747 0.0005 inch) Inside diameter ... 80.25 + 0.087 - 0.000 mm (3.159 + 0.0034 - 0.0000 inch) Install the bearing in the bearing bore. ... 7.5 0.2 mm (0.30 0.01 inch) (8) Position the four nuts past the end of the four bolts. ... 0.5 0.5 mm (0.02 0.02 inch) (9) Tighten the four nuts against four nuts (8).