DRIVE AR-BACKHOE LOADER 1745439 - Caterpillar

Install support bracket
The procedure for fastening clamps to brackets is as follows:Fastening clamps to bracket
Illustration 22 g06125112
(9) 506-0121 Bracket As
(10) 506-5792 Clamp
(11) 166-3777 Screw
(12) 8T-4205 Hard Washer
(13) 506-5791 Clamp
Install two clamps (13) and clamp (10) onto mounting bracket (9) using three screws (11) and three washers (12). Tighten screws (11) to a torque of 12 3 N m (106 27 lb in).Fastening clamps to plate
Illustration 23 g06132582
(10) 506-5792 Clamp
(11) 166-3777 Screw
(12) 8T-4205 Hard Washer
(13) 506-5791 Clamp
(14) 112-6646 Locknut
(15) 506-0122 Plate
Install two clamps (13) and clamp (10) onto mounting plate (15) using three screws (11), three washers (12) and three locknuts (14). Tighten screws (11) to a torque of 12 3 N m (106 27 lb in).Fastening bracket to box
Illustration 24 g06132585
(16) 6V-3940 Bolt
(17) 5P-4116 Hard Washer
Install mounting bracket onto box using four bolts (16) and four washers (17). Tighten bolts (16) to a torque of 28 7 N m (248 62 lb in).Harness support
Illustration 25 g06125118
(8) 7K-1181 Cable Strap
(16) 6V-3940 Bolt
(17) 5P-4116 Hard Washer
(18) 4P-8134 Clip
(19) 506-0123 Plate As
(20) 130-5300 Clip
Install clip (18) and plate (19) onto mounting bracket using three bolts (16) and three washers (17). Tighten bolts (16) to a torque of 28 7 N m (248 62 lb in).
Install clip (20) onto plate (19) using bolt (16) and washer (17). Tighten bolt (16) to a torque of 28 7 N m (248 62 lb in).
Install the strap cable (8) onto the clip (18).
Illustration 26 g06125120
(2) 231-9895 Flexible Conduit
(5) 230-4010 Connector Receptacle As
(18) 4P-8134 Clip
(20) 130-5300 Clip
Install umbilical harness connector (5) to clip (20).
Secure umbilical harness conduit (2) to ladder clip (18) using strap cable (8).Fastening clamps to bracket
Illustration 27 g06125122
(17) 5P-4116 Hard Washer
(21) 6V-5222 Bolt
Install clamps to bracket using four bolts (21) and four washers (17). Tighten bolts (21) to a torque of 28 7 N m (248 62 lb in).Note: Raise the three umbilical harness to relieve load on harness connectors before clamping.Existing umbilical harness
Illustration 28 g06125545
(U) Clips
(V) Grommets
(W) Harness
Remove existing clip (U) and grommets (V). Discard the parts.
Secure the harness insulation (W) using 290-8070 Tape.