DRIVE GP-FINAL 1769100 - Caterpillar

Illustration 7 g01384432
Use Tooling (B) in order to remove bearing (10) .
Repeat Steps 4 through 8 for the opposite side.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 8 g01384432
Illustration 9 g01384692
Illustration 10 g01384693
Lower the temperature of bearing (10). Be sure to match Dimension (B) and Dimension (C) when you are installing bearing (10). Dimension (B) indicates the angle of the joint on bearing (10). Dimension (B) is 15° 1°. Dimension (C) shows the distance from bearing (10) to the end of the bore. Dimension (C) is 4.000 0.500 mm (0.1575 0.0197 inch).
Illustration 11 g01384714
Illustration 12 g01384715
Lower the temperature of bearing (10A). Be sure to match Dimension (D) and Dimension (E) when you are installing bearing (10A). Dimension (D) indicates the angle of the joint on bearing (10A). Dimension (D) is 15° 1°. Dimension (E) shows the distance from bearing (10A) to the end of the bore. Dimension (E) is 4.000 0.500 mm (0.1575 0.0197 inch).
Illustration 13 g01384430
Install the O-ring seal and cover (9) .
Illustration 14 g01384783
Install gear assembly (8). Be sure that oil passage plug (8A) is facing outward.
Illustration 15 g01384809
Illustration 16 g01384831
Lower the temperature of bearing (7). Be sure to match Dimension (F) and Dimension (G) when you are installing bearing (7) into adapter assembly (6). Dimension (F) indicates the angle of the joint on bearing (7). Dimension (F) is 15° 1°. Dimension (G) shows the distance from bearing (7) to the end of the bore. Dimension (G) is 3.500 0.500 mm (0.1378 0.0197 inch).
Illustration 17 g01383927
Install the O-ring seal and adapter assembly (6). Install bolts (5) .
Repeat Steps 3 through 6 for the opposite side.
Illustration 18 g01384996
Lower the temperature of bearing (4). Install bearing (4) into gear assembly (3). Be sure that each relief (H) in bearing (4) is within 2° of each relief in gear assembly (3) .
Illustration 19 g01383883
Position gear assembly (3) and retainer (2). Install bolts (1) .
Repeat Steps 8 and 9 for the opposite side.End By: Install the flywheel and pump drive gear. Refer to Disassembly and Assembly, "Flywheel - Install".