DRIVE GP-SWING 1994538 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 5P-1733 Seal Locator 1
5P-1737 Bolt 3
9S-8858 Nut (Seal Installer) 1
6V-6142 Seal Installer 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The crankshaft front seal and the wear sleeve must be replaced at the same time. Once the crankshaft front seal and the wear sleeve are separated, these components cannot be used again.Note: Do not use any type of lubricant during the installation of the crankshaft front seal and the wear sleeve.
Clean the outside diameter of the crankshaft.
Illustration 1 g01116116
Use Tooling (B) to install crankshaft front seal (1) and wear sleeve (2). Note: Install the crankshaft front seal with the arrow that shows the direction of crankshaft rotation toward the front of the engine.End By:
Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".