DRIVE GP-GOVERNOR 1W2135 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Illustration 1 g01094365
Use a suitable lifting device to position unit injector hydraulic pump (2) and the O-ring seal on the engine. The weight of unit injector hydraulic pump (2) is approximately 27 kg (60 lb).
Install bolts (5).
Illustration 2 g01094363
Install support bracket (4) on unit injector hydraulic pump (2).
Illustration 3 g00884299
Connect harness assemblies (3).
Connect tube assembly (1) to unit injector hydraulic pump (2). End By:
Install the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Transfer Pump - Install".