2552877 DRIVE GP-FAN Caterpillar parts
320C, 320C FM, 320C L, 320D, 320D LRR, 321C
Rating:
Alternative (cross code) number:
CA2552877
255-2877
2552877
CA2552877
255-2877
2552877
EXCAVATOR,
Information:
Literature Information
This manual should be stored in the literature storage area.The information contained in this document is the most current information available for coolants, fuels, and lubricants. Refer to the Operation and Maintenance Manual for any special lubrication requirements for your engine.Whenever a question arises regarding the engine, this publication, or the Operation and Maintenance Manual, please consult any Cat dealer for the latest available information.Safety
Refer to the Operation and Maintenance Manual for your engine for all safety information. Read and understand the basic safety precautions listed in the Safety Section. In addition to safety precautions, this section identifies the text and locations of safety signs used on the engine.Read and understand the basic precautions listed in the Safety Section before operating or performing lubrication, maintenance and repair on this engine.Maintenance
Refer to the Operation and Maintenance Manual for your engine to determine all maintenance requirements.Maintenance Intervals
Use the Maintenance Interval Schedule in the Operation and Maintenance Manual for your engine to determine servicing intervals. The actual operating environment of the engine also governs the maintenance interval schedule. Therefore, under extremely severe, dusty, wet or freezing cold operating conditions, more frequent lubrication and maintenance than is specified in the Maintenance Interval Schedule may be necessary.Extended Engine Oil Drains and Warranty
Failures that result from extended oil drain periods are not Caterpillar factory defects and therefore are not covered by Caterpillar's warranty. In addition, failures that result from not using the recommended oil type are not Caterpillar factory defects and therefore are not covered by Caterpillar's warranty.Refer to the applicable Operation and Maintenance Manual for standard oil drain periods and to the Maintenance Section, "Lubricant Specifications" of this publication for engine oil type and viscosity grade recommendations.To reduce the potential risk of failures associated with extended oil drain periods; it is recommended that oil drain intervals only be extended based on oil analysis, and subsequent engine inspections. Oil analysis alone does not provide an indication of the rate of formation of lacquer, varnish and/or carbon on pistons and other engine surfaces. The only accurate way to evaluate specific oil performance in a specific engine and application that utilizes extended oil drain periods is to observe the effects on the engine components. This involves tear-down inspections of engines that have run to their normal overhaul period with extended oil drain intervals. Following this recommendation will help ensure that excessive component wear does not take place in a given application.
Light loads, low hour accumulation, and excessive idling time can contribute to excessive water in the crankcase oil. Corrosive damage, piston deposits and increased oil consumption can also result. If oil analysis is not done or the results are ignored, the potential for corrosive damage and piston deposits increases. Refer to the appropriate Operation and Maintenance Manual for guidance.
Note: Failures that result from extended oil drain periods are not warrantable failures, regardless of use of this recommended procedure. Failures that result from extended engine oil drain periods are considered improper use under the warranty.Aftermarket Products
This manual should be stored in the literature storage area.The information contained in this document is the most current information available for coolants, fuels, and lubricants. Refer to the Operation and Maintenance Manual for any special lubrication requirements for your engine.Whenever a question arises regarding the engine, this publication, or the Operation and Maintenance Manual, please consult any Cat dealer for the latest available information.Safety
Refer to the Operation and Maintenance Manual for your engine for all safety information. Read and understand the basic safety precautions listed in the Safety Section. In addition to safety precautions, this section identifies the text and locations of safety signs used on the engine.Read and understand the basic precautions listed in the Safety Section before operating or performing lubrication, maintenance and repair on this engine.Maintenance
Refer to the Operation and Maintenance Manual for your engine to determine all maintenance requirements.Maintenance Intervals
Use the Maintenance Interval Schedule in the Operation and Maintenance Manual for your engine to determine servicing intervals. The actual operating environment of the engine also governs the maintenance interval schedule. Therefore, under extremely severe, dusty, wet or freezing cold operating conditions, more frequent lubrication and maintenance than is specified in the Maintenance Interval Schedule may be necessary.Extended Engine Oil Drains and Warranty
Failures that result from extended oil drain periods are not Caterpillar factory defects and therefore are not covered by Caterpillar's warranty. In addition, failures that result from not using the recommended oil type are not Caterpillar factory defects and therefore are not covered by Caterpillar's warranty.Refer to the applicable Operation and Maintenance Manual for standard oil drain periods and to the Maintenance Section, "Lubricant Specifications" of this publication for engine oil type and viscosity grade recommendations.To reduce the potential risk of failures associated with extended oil drain periods; it is recommended that oil drain intervals only be extended based on oil analysis, and subsequent engine inspections. Oil analysis alone does not provide an indication of the rate of formation of lacquer, varnish and/or carbon on pistons and other engine surfaces. The only accurate way to evaluate specific oil performance in a specific engine and application that utilizes extended oil drain periods is to observe the effects on the engine components. This involves tear-down inspections of engines that have run to their normal overhaul period with extended oil drain intervals. Following this recommendation will help ensure that excessive component wear does not take place in a given application.
Light loads, low hour accumulation, and excessive idling time can contribute to excessive water in the crankcase oil. Corrosive damage, piston deposits and increased oil consumption can also result. If oil analysis is not done or the results are ignored, the potential for corrosive damage and piston deposits increases. Refer to the appropriate Operation and Maintenance Manual for guidance.
Note: Failures that result from extended oil drain periods are not warrantable failures, regardless of use of this recommended procedure. Failures that result from extended engine oil drain periods are considered improper use under the warranty.Aftermarket Products
Caterpillar SIS machinery equipment:
Caterpillar SIS
320C & 320C L Excavators MAB00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C & 320C L Excavators MAB00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C U & 320C LU Excavators MAC00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C U & 320C LU Excavators MAC00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
321C LCR Hydraulic Excavator MCF00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
321C LCR Hydraulic Excavator MCF00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C Forest Machines SAH00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C Forest Machines SAH00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C & 320C L Excavators RAW00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C & 320C L Excavators RAW00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C LRR Excavator GAD00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C LRR Excavator GAD00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C & 320C L Excavators GNG00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C & 320C L Excavators GNG00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320D RR & 320D LRR Excavators EBY00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320D & 320D L Excavators CXY00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320C L Excavator EAG00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
320D & 320D L Excavators JGZ00001-UP (MACHINE) POWERED BY 3066 Engine »
255-2877
DRIVE GP-FAN
Caterpillar parts catalog:
Parts drive Caterpillar catalog:
2276116
DRIVE GP-FINAL
320C, 320C FM, 320D, 320D FM, 322C, 323D LN, 325C, 325C L, 325D, 325D L, 325D MH
320C, 320C FM, 320D, 320D FM, 322C, 323D LN, 325C, 325C L, 325D, 325D L, 325D MH
1484644
DRIVE GP-SWING
318C, 319C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D LN, 323D SA,...
318C, 319C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D LN, 323D SA,...
2276035
DRIVE GP-FINAL
315C, 315D L, 318C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D LN, 320D LRR, 320D RR, 321B, 321C, 321D LCR, 323D L
315C, 315D L, 318C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D LN, 320D LRR, 320D RR, 321B, 321C, 321D LCR, 323D L
1912682
DRIVE GP-FINAL
320C, 320C FM, 325C, 325C FM
320C, 320C FM, 325C, 325C FM
2276949
DRIVE GP-FINAL
318C, 319C, 319D, 319D LN, 320C, 320D, 320D L, 323D L, 323D LN
318C, 319C, 319D, 319D LN, 320C, 320D, 320D L, 323D L, 323D LN
1915537
DRIVE GP-AUXILIARY PUMP
320C, 320C FM, 320D, 320D FM, 320D L, 320D LRR, 320D RR, 321C, 321D LCR, 322C, 322C FM, 323D L, 324D FM, 324D FM LL, 325C, 325C FM, 325C L, 325D, 325D FM, 325D FM LL, 325D MH, 328D LCR, 329D L, 329E, ...
320C, 320C FM, 320D, 320D FM, 320D L, 320D LRR, 320D RR, 321C, 321D LCR, 322C, 322C FM, 323D L, 324D FM, 324D FM LL, 325C, 325C FM, 325C L, 325D, 325D FM, 325D FM LL, 325D MH, 328D LCR, 329D L, 329E, ...
2648755
DRIVE GP-PUMP
320D LRR, 320D RR
320D LRR, 320D RR
2813588
DRIVE AS-FAN
320D, 320D FM, 320D FM RR, 320D L, 320D LN, 320D LRR, 320D RR, 321C, 321D LCR, 323D L, 323D LN
320D, 320D FM, 320D FM RR, 320D L, 320D LN, 320D LRR, 320D RR, 321C, 321D LCR, 323D L, 323D LN
7N8971
DRIVE GP-FAN
3408, 3408C, 3408E, 3412, 3412C, 3412E, G3412
3408, 3408C, 3408E, 3412, 3412C, 3412E, G3412
1803397
DRIVE GP-FAN
D10R
D10R
1258523
DRIVE GP-FAN
D8R, D8R II
D8R, D8R II
2416715
DRIVE GP-ACCESSORY
G3512E, G3516C, G3516E, G3520C, G3520E, PMG3516
G3512E, G3516C, G3516E, G3520C, G3520E, PMG3516
9Y5165
DRIVE GP-FAN
3208
3208
2258809
DRIVE GP-AUGER
305.5E, 305E, 308E2 CR, A26B
305.5E, 305E, 308E2 CR, A26B