DRIVE GP-CIRCLE 2595580 - Caterpillar

Illustration 1 g01795513
Typical example
(1) Bore of the bearings in the bracket assemblies after installation ... 21.925 0.015 mm (0.8632 0.0006 inch) (2) Diameter of the surfaces for the bearings and the rod assemblies on the shafts ... 21.850 0.015 mm (0.8602 0.0006 inch) (3) Bore of the bearings in the two support assemblies after assembly ... 21.925 0.015 mm (0.8632 0.0006 inch) (4) Torque for the pin ... 10 2 N m (90 18 lb in)
Illustration 2 g01795514
Front view
(5) Torque for the locknuts at each end of the bellcrank ... 8 2 N m (70 18 lb in) (6) Torque for the plugs ... 25 5 N m (18 4 lb ft) (D) Clearance between the lever assemblies on the front cross shaft and the side shafts ... 0.20 0.10 mm (0.008 0.004 inch)