DRIVE GP-FINAL 2652299 - Caterpillar

1. Remove screw (1), bolts (2) and cover (3).2. Remove stop assembly (6), and nuts (7) and (8).3. Remove bolt (4), screws (5) and cover (10).4. Remove diaphragm group (11).5. Remove spring (14) and retainer (16).6. Remove the bolts and remove the housing (15). 7. Rotate rod assembly (9) counterclockwise to disengage the rod assembly and link assembly (13) from pin (17) and remove as a unit.8. Remove pin and washer (12). Separate the rod and link assemblies. The following steps are to install.9. Assemble rod assembly (9) to link assembly (13) and install pin and washer (12).10. Install the rod and link assembly as a unit into the governor housing. Rotate the rod and link assembly clockwise to engage the slot of the link assembly over pin (17).
Typical Example If necessary, remove the two top bolts that hold the governor housing to the governor cover. Loosen, but do not remove, the bottom four bolts. Use a small pick to help position the slot in the link assembly over pin (17).11. Install housing (15) and the bolts.12. Install spring (14) and retainer (16).13. Install diaphragm group (11).14. Install cover (10), bolt (4) and screws (5).15. Install nuts (8) and (7), and stop assembly (6).16. Adjust air fuel ratio control. (For adjustment procedures, refer to "Setting and Adjusting of Bosch Fuel Pump," Form No. SEHS9036.)17. Install cover (3), screw (1) and bolts (2).