DRIVE GP-AUXILIARY 2915535 - Caterpillar

Removal Procedure
Start By:
Release the hydraulic system pressure. Refer toDisassembly and Assembly , "System Preasure - Realease".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all hoses, on all hose assemblies, on all harness assemblies, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Drain the hydraulic tank into a suitable container for storage or for disposal. Refer to Operation and maintenance Manual, "Hydraulic System Oil - Change " for the proper procedure.
Illustration 1 g01665739
Remove panel assembly (1).
Illustration 2 g01665754
Remove panel assembly (2).
Illustration 3 g01665776
Illustration 4 g01665786
Remove step (3). Remove toolbox (4). Disconnect harness assembly (5) and hose (6).
Illustration 5 g01665814
Disconnect hose (7) and remove clamp assembly (8).
Illustration 6 g01665840
Disconnect hose assembly (9) and remove tube assembly (10).
Illustration 7 g01665933
Disconnect hose assembly (11).
Illustration 8 g01665953
Disconnect harness assembly (12). Remove bolts and check valve (13).