DRIVE GP-SWING 3333015 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0510     Driver Group     1    
B     1P-1861     Pliers     1    
Illustration 1 g00292544
(7) Bolt (8) Impeller (11) Ceramic ring (12) Seal (14) Water pump housing (15) Washer (16) Spring (17) Seal
Illustration 2 g00290696
(2) Bearing (3) Pump gear (4) Retaining ring (9) Bearing (10) Shaft (13) Lip seal (14) Water pump housing
Illustration 3 g00292855
Use Tool (A) in order to install lip seal (13) .
Illustration 4 g00290694
Install seal (12) and install ceramic ring (11) .
Illustration 5 g00292887
Use Tool (A) and a press in order to install shaft (10) onto bearing (9) .
Illustration 6 g00290290
Install shaft (10) and bearing (9) as a unit.
Illustration 7 g00292892
Install seal (17) and position spring (16) onto seal (17) .
Illustration 8 g00290593
Position impeller (8) and install washer (15) and bolt (7). Torque bolt (7) to 55 10 N m (40 7 lb ft).
Illustration 9 g00290289
Position cover (6) and install bolt (5) .Note: Check condition of the gasket that was removed. Replace worn gaskets and damaged gaskets. Use only new Caterpillar parts.
Illustration 10 g00290268
Use Tool (B) in order to install retaining ring (4) .
Illustration 11 g00295214
Use Tool (A) and a press to install bearing (2) onto pump gear (3) .
Illustration 12 g00290218
Position pump gear assembly (3) and bearing (2) onto the pump housing, and install twelve point head bolt (1). Tighten twelve point head bolt (1) to 97 7 N m (72 5 lb ft).End By: Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Remove and Install". The information is in this manual.