DRIVE GP-FINAL 4526207 - Caterpillar

performing any operation or maintenance procedures, ensure that the safety information, warnings, and instructions are read and understood.Failure to adhere to proper maintenance intervals may result in the degradation of the engine's performance and/or the accelerated wear of the engine's components.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.When Required
Battery or Battery Cable - Disconnect
Cooling System Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element - Clean/Replace
Fuel System - Prime
Generator - Dry
Generator Set - Test
Overhaul Considerations
Space Heater - Check
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Cooling System Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Generator Load - Check
Walk-Around Inspection
Every Week
Standby Generator Set Maintenance Recommendations
Every Year
Generator Set Vibration - Inspect
Every 3800 L (1000 US gal) of Fuel or 50 Service Hours
Engine Air Precleaner - Clean
First 13 000 L (3400 US gal) of Fuel or 250 Service Hours
Engine Valve Lash - Inspect/Adjust
Magnetic Pickups - Clean/Inspect
Every 13 000 L (3400 US gal) of Fuel or 250 Service Hours
Battery Charger - Check
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Primary Filter - Clean/Replace
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 51 000 L (13 500 US gal) of Fuel or 1000 Service Hours
Engine Protection Devices - Calibrate
Fuel Control Linkage - Check/Lubricate
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Cooling System Coolant Sample (Level 2) - Obtain
Every 153 500 L (40 500 US gal) of Fuel or 3000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Fuel Ratio Control - Inspect/Adjust
Turbocharger - Inspect
Every 256 000 L (67 500 US gal) of Fuel or 5000 Service Hours
Alternator - Inspect
Fuel Injection Nozzles - Test/Exchange
Magnetic Pickups - Clean/Inspect
Starting Motor - Inspect
Water Pump - Inspect
Every 306 000 L (81 000 US gal) of Fuel or 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change