DRIVE GP-FINAL 4787556 - Caterpillar

Personal injury or death can result from a fire.Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system.Turn the disconnect switch OFF or disconnect the battery when changing fuel filters.
Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.
Open the access door on the left side of the machine.
Illustration 1 g00832272
(1) Drain hose
(2) Drain valve
(3) Fuel filter Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
Position a suitable container for the used fluid under drain hose (1).
Open the drain valve (2). Allow the fuel in the filter (3) to drain into the container.
Securely tighten the valve. Note: Dispose of the used fuel according to local regulations.
Remove fuel filter (3).
Inspect the fuel filter for debris by cutting the fuel filter open. Note: This fuel filter is a cartridge type filter. This type of filter cannot be reused.
Clean the mounting base of the fuel filter. Make sure that all of the old seal is removed from the mounting base.
Illustration 2 g00101318
Apply a thin coat of clean diesel fuel onto the sealing surface of the new fuel filter.
Place the new fuel filter onto the base. Rotate the fuel filter until the filter seal contacts the base. Note the position of the index marks on the filter relative to a fixed point on the filter base. Note: Index marks on the fuel filter are separated by 90 degrees or 1/4 of a rotation.
In order to properly tighten the filter, rotate the filter by 270 degrees or 3/4 of a rotation.
Prime the fuel system. See Operation and Maintenance Manual, "Fuel System - Prime" for instructions.
Close the access door on the left side of the machine.