DRIVE GP-FINAL 5150070 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Fuel System - Prime
Generator - Dry
Generator Set - Test
Generator Set Alignment - Check
Daily
Coolant Level - Check
Engine Oil Level - Check
Generator Load - Check
Trailer - Inspect
Walk-Around Inspection
Every 6000 Service Hours or 3 Years
Coolant (ELC) - Change
Every Week
Automatic Start/Stop - Inspect
Battery Charger - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Fuel System Water Separator - Check/Drain
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Generator Bearing Temperature - Test/Record
Stator Winding Temperature - Test
Voltage and Frequency - Check
Every 250 Service Hours
Radiator - Clean
Every 250 Service Hours or 6 Months
Battery Electrolyte Level - Check
Every Year
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 2) - Obtain
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Valve Lash - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fumes Disposal Filter Element - Replace
Generator Bearing - Lubricate
Generator Set Vibration - Test/Record
Hoses and Clamps - Inspect/Replace
Starting Motor - Inspect
Every 3 Years
Coolant Temperature Regulator - Replace
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Coolant Extender (ELC) - Add