DRIVE GP-FINAL 5150073 - Caterpillar

and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Circuit Breakers - Reset
Coolant Extender (ELC) - Add
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Generator - Dry
Generator Bearing Temperature - Test/Record
Generator Set - Test
Generator Set Alignment - Check
Daily
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Voltage and Frequency - Check
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every Week
Generator - Inspect
Generator Lead (Flat Braided Cable) - Check
Initial 250 Service Hours
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Every 250 Service Hours or 6 Months
Battery Electrolyte Level - Check
Engine Oil Sample - Obtain
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Every 500 Service Hours or 1 Year
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Grounding Stud - Inspect/Clean/Tighten
Every 2000 Service Hours or 1 Year
Engine Crankcase Breather - Clean
Generator Lead (Round Cable) - Check
Generator Set Vibration - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Engine Performance - Test
Rotating Rectifier - Inspect/Test
Every 3000 Service Hours or 3 Years
Alternator - Inspect
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Rotators - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 4000 Service Hours or 2 Years
Coolant (DEAC) - Change
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Overhaul
Overhaul Considerations