DRIVE-FINAL-YM 5230574 - Caterpillar

A. D3 Tractor
Remove hydraulic tank breather and install an airtight plug. Start the engine. Lift the blade fully and completely retract the tilt cylinder. Remove the cap for the hydraulic tank to release any pressure and then tighten the cap. Level the blade and lower it to the ground. Stop the engine.B. 910 Wheel Loader and 931 Traxcavator
Remove hydraulic tank breather and install an airtight plug. Remove the cap for the hydraulic tank to release any pressure and then tighten the cap. Start the engine. Lift the bucket approximately 3 ft. (0.91 m) from the ground. Put the bucket in the DUMP position. Lower the bucket to put the cutting edge on the ground. Stop the engine.
Do not install the adapter in the supply line from the pump with the engine running. Injury to personnel can result.
1. Remove the plug or cap for the tee test from the supply line from the pump.2. Install the adapter. Install the adapter as rapidly as possible to keep the oil loss at a minimum.3. Install the return line assembly.4. Connect the return line assembly and the adapter for the pump supply line to the flow meter with the correct connecting hose assemblies. A plain coupler will not open the valve in the adapter for the supply line or return line assembly.5. Install the tachometer generator with the correct drive.6. Install the cable between the generator and the input connection for the tachometer (rpm) on the flow meter.