DRIVE GP-FEED 5423697 - Caterpillar

Illustration 76 g00676119
The cylinder brackets (54) should be symmetrical to the face of the boss within 0.5 mm (0.0197 inch). Refer to dimension (54A) in Illustration 76.The pin bores of the bracket should be parallel to the centerline of the boss within 0.2 mm (0.0079 inch). The dimension of the bore diameter is measured after the cylinder brackets are welded to the stick. Refer to dimension (54B) in Illustration 76. (54) Cylinder brackets
Place the cylinder brackets (54) on the stick. Refer to Illustration 76, 77 and 78. The placement of the cylinder brackets is critical.
Illustration 77 g00676118
The welds on the ends of the cylinder brackets should be ground.