DRIVE GP- 5575885 - Caterpillar

Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again.Turbocharger (if equipped) damage can result, if the engine is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient.
Key must be in the ON position with engine running to maintain electrical and hydraulic functions and prevent serious machine damage.
Illustration 1 g00406959
Insert the disconnect switch key into the battery disconnect switch. Turn the battery disconnect switch to the ON position.
Illustration 2 g00414158
Make sure that the reset button for the circuit breaker remains depressed.
Illustration 3 g00414687
Move the hydraulic activation control lever to the LOCKED position.This machine is equipped with an engine neutral start system. The system only allows the engine to start when the hydraulic activation control lever is in the LOCKED position.
Move the implement control levers to the HOLD position.
Illustration 4 g00422627
Turn the engine start switch to the ON position.
Illustration 5 g00422626
All of the indicators on the monitor panel should be activated and the action alarm should sound for approximately 2.5 seconds. If any of the indicators are not activated or if the action alarm does not sound, check the electrical system. Make any necessary repairs before you start the engine.
Illustration 6 g00345992
Turn the engine speed dial to the MEDIUM SPEED position.
Illustration 7 g00422629
Turn the engine start switch to the START position.
Release the engine start switch key after the engine starts.