DRIVE-SQUARE 6V2079 - Caterpillar

Illustration 1 g00678905An example of a data event with “switch information” is shown here:
Illustration 2 g00569208245.2 is the service meter reading at the start of the event. 000:04:13 is the duration of the event in HHH:MM:SS format. The "2" that follows the “event duration” represents the warning category 2.Press the "F1" key while you view a machine event. This function will replace the information that is shown on the second line of the message area. The new information that is shown contains information about the maximum values that were measured for the parameter such as “2266 RPM” or “LO (switch)”. Pressing the "OK" key puts the message center back into the previous mode. See the Systems Operation, "Keypad" topic for additional information. Pressing the "OK" key again, puts the message center back into the original mode. System/Diagnostic Events The following information is shown in the VIMS message area for each system event in the event list.
The name of the parameter
The status of the parameter
Service meter reading at the start of the event
The event duration
The event categoryAn example of a maintenance type of service event with “sensor information”:
Illustration 3 g00678904245.2 is the service meter reading at the start of the event. 000:04:13 is the duration of the event in HHH:MM:SS format. The “2” is the warning category.When you view a diagnostic event, press the "F1" key to replace the information that is shown on the second line of the message area. The information in the message area is replaced with the "MID-CID-FMI". The message center can be returned to the original mode by pressing the "OK" key. The FORWARD and BACKWARD arrow keys are used to scroll through the event list. Reference: Systems Operation, "Keypad"