DRIVE-CONTROL END 7J6839 - Caterpillar

Identify which COM PORT that the USB-to-Serial Adapter Is Using
To identify the COM port that the adapter is installed on, perform either Procedure 1 or Procedure 2.Procedure 1
Connect the USB-to-Serial device to the USB port on the laptop.
Click on "Start", "Settings", "Control Panel", and "System".
In the System Properties window, click on the "Hardware" tab.
In the Device Manager section, click on the "Device Manager" button.
In the Device Manager window, click on the "+" next to "Ports (COM and LPT)". There should be an entry for a USB-to-Serial Comm Port followed by the assigned COM port number (COM6 in the example below). Record this COM port, as it will be used in later steps.
Illustration 1 g01134864
Procedure 2
Right-click on the "My Computer" icon on the Desktop.
Scroll down on the drop-down menu and select "Manage".
Illustration 2 g01134876
From the "Computer Management" Window, select "Device Manager".
Illustration 3 g01134859
On the right window of the "Computer Management" screen, click on the "+" next to "Ports (COM and LPT)" to expand the selection.
Record the COM port information next to the USB-to-Serial device.Change the Default COM PORT Setting
Connect the USB-RS232 Adapter to the PL102C Service Cable and start the Caterpillar Service Tool software.The service tool will attempt to connect automatically to the last used COM port (COM1 by default). If the attempt to connect fails, the startup screen will go away but the software will continue to attempt to connect to the PL102C.Note: The Service Tool will display the COM port it is using for the connection attempt in the lower portion of the screen ("Connecting to the device...." and "Comm Port 1 is Open" are displayed in Illustration 4). Also note the indicator in the upper right corner of the screen. This indicator can be illuminated either red or green:Red - No communications have been established with the module.Green - The Service Tool has established communications with the module.
Select the COM port as recorded in Step 5 above.
Illustration 4 g01134904
In order to select a new COM port, you must first abort the connection process. This can be accomplished by clicking on the "Actions" menu bar and clicking on "Disconnect" as shown in Illustration 5.Note: During the connection process, the "Options" drop-down menu (used to change the COM Port setting) is not available (grayed out).
Illustration 5 g01134874
Now that the connection process has been interrupted, the "Tools/Options" menu entry is enabled. Click on the "Tools" menu bar entry and select "Options" as shown in Illustration 6.
Illustration 6 g01134914
In the Options Window (Illustration 7), select the appropriate COM port (as recorded in Step 5 above) from the "Comm Port:" drop down box. Click OK.
Illustration 7 g01134849
Attempt to re-connect by clicking on the "Action" menu bar entry and clicking on "Connect". The connection should be established as shown in the example below.Note: The indicator in the upper right corner of the Service Tool will change to green upon connection to the module and display "Connected Comm Port 6" as shown in Illustration 8.
Illustration 8 g01134907