DRIVE GP-FAN 7N8838 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-0306     Vacuum Transducer     1    
FT-1115 Vacuum Cap     1    
6V-4142 Fitting     1    
5K-5068 Fitting     1    Note: Check the O-ring seals for wear or for damage. Replace the O-ring seals, if necessary.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01175949
Position drift reduction valve (10) and install bolts (9) .
Illustration 2 g01175948
Install connector (8). Connect tube assembly (7) to connector (8). Connect hose assembly (6) .
Illustration 3 g01175946
Tighten clamp (5) .
Illustration 4 g01175945
Install covers (2) and (3) .
Illustration 5 g01175943
Connect hose assemblies (2) .
Illustration 6 g01175940
Install cover (1) which is located under the main control valve.
Illustration 7 g00944947
Remove Tooling (A). Install the cap onto the hydraulic tank.
Fill the hydraulic system. Refer to Operation and Maintenance, "Hydraulic System Oil Level - Check". Refer to Operation and Maintenance, "Lubricant Viscosities and Refill Capacities".