DRIVE SHAFT GP 8D5070 - Caterpillar

8D5070 DRIVE SHAFT GP Caterpillar parts 623B

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA8D5070
8D-5070
8D5070

Weight: 8 pounds 3 kg.

Buy DRIVE SHAFT GP 8D5070 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL TRACTOR,

Compatible equipment models: 8D5070:

WHEEL TRACTOR 623B Caterpillar

Number on catalog scheme:

Caterpillar 8D5070 Parts scheme DRIVE SHAFT GP

For full view, you need register

Information:

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Illustration 1 g00312363
In-line filter (1) is positioned at the right rear of hydraulic tank (2) .
Illustration 2 g00312366
In-line filter (3) is positioned between the swing motor and the swivel.
Loosen the fill/vent plug in order to relieve the hydraulic tank pressure. Tighten the fill/vent plug after the hydraulic tank pressure is relieved.
Separate the hydraulic lines at in-line filter (1) and at in-line filter (3) .Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
Remove the in-line filter from the holders.
Wash the in-line filter in a clean, nonflammable solvent. Allow the in-line filter to dry.
Clean the holders. Inspect the O-ring seals of the holders. If damage or wear is found, replace the O-ring seals.
Install in-line filter (1) and in-line filter (3) . Install the in-line filter into the holders.
Connect the hydraulic lines.